www.marketdirect.com.au
Ph: 1300 494 494
©Copyright
Suspension
Suspension maintenance should be done as per the schedule contained in this booklet. Regular lubrication and
inspection are critical, and the grease points are indicated below. Regular checks of the torque on the trailing
arm bolts indicated will prolong correct wheel alignment.
Trailing arm suspension should not be reversed up gutters and obstructions in a heavy matter. Always use a
ramp or similar if you are backing over high gutters and obstacles.
Spare Part Numbers
Hub & Suspension Components
Timken Bearing (inner & outer bearings)
Bearing Cone (Inner and outer bearings)
50 x 50mm square Poly Orange Bush
Steel Bush Insert 30 x 114mm
LHS Backing plate Assemble (with pads)
RHS Backing Plate Assembly (With Pads)
To Next Page
Loading...
