MDC ROBSON XTT - Operating Modes (Control Panel)

www.mdcusa.com Ph: 833 632 8721
52
Operating Modes (control panel)
AquaGo comfort / AquaGo comfort plus
A control panel to select the operating mode (included with the delivery from serial number DLE60X(X)27100000).
With the rotary switch (Fig. 9) you can choose between the following operating modes:
Sign Operating mode/ Description
ECO
The appliance is now running in energy-saving mode.
• Water temperature at the outlet is approximately 120 °F (49 °C).
• Prevention of freezing by using propane gas. The temperature in the
appliance is automatically kept above 41 °F (5 °C) .
• During operation, the yellow status LED 3 is lit.
COMFORT
The appliance is now running in a mode that provides rapid availability of hot
water.
• Water temperature at the outlet is approximately 120 °F (49 °C).
• Stand-by heat. The temperature in the appliance is automatically kept
above 102 °F (39 °C).
• During operation, the yellow status LED 3 is lit.
Off
Stand-by. The appliance is not running in any operating mode.
• The yellow status LED 3 is off.
To switch off the POWER and gas supply refer to “Switching OFF the
appliance” on page 53.
ANTIFREEZE
Prevention of freezing using 12 VDC electricity:
Operating mode with installed electric antifreeze kit (available as an
accessory) and appliance switched on. The temperature in the appliance is
automatically kept above 41 °F (5 °C).
• During operation, the yellow status LED 3 is lit.
Clean
DECALCIFICATION
Only AquaGo comfort / AquaGo comfort plus. See “Decalcication” on page 58.
For safety reasons, after 30 seconds the decalcication process cannot be
stopped until the system has been rinsed in accordance with the
instructions. See “Interrupting decalcication” on page 63.