MDC ROBSON XTT - Page 59

www.mdcusa.com Ph: 833 632 8721
59
Decalcication (models with control panel)
AquaGo comfort / AquaGo comfort plus with control panel (included with delivery).
An integrated water consumption meter recognizes (after hot water consumption of approx. 1585 gallons /
6000 l) that decalcication is necessary. The assumed water hardness is “hard” and cannot be changed. The yellow
status LED 3 (Fig. 9) indicates that decalcication is necessary (goes off briey about every 7 seconds).
Irritation of skin and eyes in case of contact with decalcication agent
Wear protective gloves, eye protection and face protection to avoid contact.
• Never use the water supply in the RV during decalcication
• In case of skin contact with the decalcication agent, immediately rinse the affected area with plenty of
water.
• In case of eye contact, hold eyelid open and rinse with running water for 10 – 15 min. Remove contact
lenses, if present and easy to do. Continue rinsing. Consult an eye specialist.
• If you swallow the decalcication agent, immediately rinse your mouth and drink plenty of water in
small sips. Do not vomit. Consult a doctor.
The use of non original AquaGo decalcication tablets (e.g. vinegar) for decalcication can cause chemical
reactions and produce hazardous substances that could enter the drinking water supply.
• Do not mix AquaGo decalcication tablets with other substances to avoid chemical reactions and
production of hazardous substances.
• Use only AquaGo decalcication tablets to decalcify the appliance to avoid:
- chemical reactions and production of hazardous substances,
- damage to your appliance,
- and the voiding of your warranty.
- Call your local AquaGo dealer or service provider or see www.truma.com for more information on how
to obtain AquaGo decalcication tablets.
WARNING
During decalcication, you must also observe the following
• Damage to the appliance if decalcication is interrupted.
- You must complete the decalcication process and then rinse thoroughly with clean water.
- Allow about 3 hours for decalcication. The appliance works on its own for most of this time.
• Sensitive surfaces (e. g. marble) may be damaged through contact with the decalcication agent.
- Immediately remove splashes of decalcication