MDG ATMe - Working with the ATMe; Powering On and Initialization

ATMe, Haze Generator
User Guide, Rev: C/e, March 2023 9 / 33
Working with the ATMe
The MDG ATMe Haze Generator is quite easy to operate and requires no preventive maintenance.
Switch On the power.
The MDG ATMe will display during four (4) seconds, the following message:
MDG Fog Generators
BootLoader
Testing: ....
These four seconds allow you to connect the generator to your PC, via a USB cable, to update the firmware
of the control board (see BootLoader for further details).
Then, the MDG ATMe will display during one (1) seconds, the following message:
ATMe
by
MDG Fog Generators Ltd
(V: x.xx – F: y.yyy)
where ‘x.xx’ is the version of your generator, and ‘y.yyy’ is the firmware of the program.
The program will load the configuration parameters saved in the EEPROM memory.
Finally, the screen will display the menu.