MDS 05-3316A01, Rev. E MDS 4710B/9710B I/O Guide 19
NOT AVAILABLE—The entered command or parameter was valid, but it
referred to a currently unavailable choice.
PASSWORD INVALID—The entered password was invalid, and was not
accepted.
ACCESS DENIED—The command is invalid for the current password
level.
EEPROM FAILURE—The INIT command is unable to write to EEPROM.
This is a serious internal error; contact MDS.
5.2 Command Summary
Table 8 is a command list applicable to the MDS x710 radios. Table 9
is a list of the Local Maintenance commands that can be used to adjust
items such as operating frequency. These tables are summaries only.
Refer to 5.4 Detailed Command Descriptions for more comprehensive
information regarding the use of each command.
Invisible place holder
Table 8. Operating parameter commands
Command name Function
BAUD [9600 abc] Details
page 22
Set or display the DATA INTERFACE data rate
and control bits.
CTS [0–255] Details page
23
Set or display the Clear-to-Send delay in
milliseconds.
DIAGLEV [OFF, 1,2,3]
Details page 23
Set or display the diagnostics level compatible
with the MDS 2300 and 4300 Series radios.
DKEY Details page 24 Dekey the radio (transmitter OFF). This is
generally a radio test command.
DP Details page 24 Local maintenance command that decrements
transmit power.
DSTE Details page 24 Disable the Squelch Tail Eliminator function.
DUMP Details page 24 Display all programmable settings.
EMP [ON, OFF] Details
page 24
Display or change the emphasis/de-emphasis
characteristics of the radio.
ESTE Details page 24 Enable the Squelch Tail Eliminator function.
HREV Details page 25 Display the Hardware Revision level.
INIT Details page 25 Set radio parameters to the default values
KEY Details page 26 Key the radio (transmitter ON), This is generally a
radio test command.
LBC [xxxx] Details page
26
Set or display the loopback code of the radio.
MODEL Details page 26 Display the Model number of the radio.
To Next Page
Loading...
