Mea Hawk - Page 24

MEA INC
2600 American Lane | Elk Grove Village, IL 60007 | USA
T +1 847 766 9040 | F +1 847 350 1951
COMPLETE CONTROL
www.meaincorporated.com
MEA Incorporated | Hawk Actuator Instruction and Operation Manual
02/2018 24
3) The first screen of the Setup menu is devoted to the actuator tuning parameters. This screen is
covered in detail in Section 4-1. Press the “Next” button to access the position calibration
screens.
4) If the actuator has not already been coupled to the valve/damper use the arrow buttons to move
the actuator into place and align with the valve/damper according to Section 5-2.
5) Press the “Reset Teach Points” button and then press the “Next” button.
6) Use the arrow buttons to move the actuator to the Retracted (or Counter-Clockwise) endpoint. If
a control signal is being applied, it will appear in the “Control Signal” field on the right of the
screen. Change the control signal to match the desired signal for this actuator position. (For
example, if the actuator was Retract on Increasing signal, set the control signal to 20 mA)