DC32D GENSET CONTROLLER USER MANUAL
6
1. Summary
This Controller Series is specialized for small diesel, gasoline, gas generator sets,
start, stop,monitor and defaults checking as well as parameters setting.
This controller has manual start, stop, and AMF functions.It has a point array LCD
screen, can display various faults in the same time that the genset will be stopped
once it can not work smoothly.
The controller has built-in simplified Chinese, traditional Chinese, English, Spanish,
Russian, Türkiye, French and other display interfaces for selection, more language
can be set according to user’s request. All the parameters can be configured through
the front face buttons or use programmable interface by USB to adjust via PC. It can
be widely applied for all kinds of auto control system of gensets.
2. Main Features
32 units Micro-procession technology is used.
1.8 inches 128*64 LCD display with backlight, option language interface , user’s
language set if necessary.
PC front face panel, which is water-proof, oil-proof, UV proof so that the durability
is longer.
It has AMF function, which can monitor the status of mains electricity and power
generation, and automatically control the ATS conversion switch;
USB Port: parameters can be set even without power.
All the parameters can be set through front panel buttons.
Collect and display a variety of engine and generator parameters.
Records function: relative faults shall be recorded in real time.
It has 5 relay outputs, 1 of which are configurable, and more than 10 functions can
be selected for each channel.
2 switch value input, and each can be set as max 10 functions.
2 sensor simulation input connectors, various kinds of units can be set.
Sensor can be self-defined by front face button or PC software.
Various of crank conditions(RPM,Frequency) can be chosen
Control Protection:Auto Start/Stop of genset,load transfer and perfect failure
display and protection.
Standard water-proof rubber gasket. The waterproof can reach IP65.
Module design: All the connections are adapted with European connectors so that
installation, connection, repair and replacement can be more easily.
3. Parameters Display
Engine RPM
Engine temperature
Engine fuel level
Engine battery voltage
Generator voltage L-N
Generator Frequency Hz
Successful start Times
Current running time
Total running time
Classes maintenance notice
Input state
Output state
Mains phase voltage L-N
Mains phase voltage L-L
To Next Page
Loading...
