To Next PageTo Next Page
Need help?Do you have a question about the Mec 3084RT and is the answer not in the manual?
General| Platform Capacity | 250 kg |
|---|---|
| Horizontal Reach | 20.8 m |
| Weight | 21, 500 kg |
| Drive Type | 4 x 4 |
| Turntable Rotation | 360° continuous |
| Platform Height | 28.7 m |
| Power Source | Diesel |
| Fuel Type | Diesel |
| Max Working Height | 30.7 m |
| Max Platform Height | 28.7 m |
| Working Height | 30.7 m |
| Machine Width | 2.49 m |
| Stowed Height | 3.1 m |
| Wheelbase | 3.3 m |
Explains safety symbols, colors, and signal words used in MEC manuals and decals, along with general maintenance advice.
Details technical specifications for RT models, including dimensions, lift capacity, and power systems.
Details technical specifications for ES models, including dimensions, lift capacity, and power systems.
Provides critical safety advice, including never servicing an elevated platform without support and using proper lifting equipment.
Explains hydraulic system warnings, fluid properties, and general maintenance precautions.
Covers electrical system safety, battery handling, and potential hazards like sparks and explosions.
Explains the operation of emergency stop and lowering systems, including critical safety warnings.
Provides safety instructions and step-by-step procedures for safely lifting and supporting the machine using jacks and stands.
Describes the integrated hydraulic circuit, load-sensing system, and pump operation for controlling machine functions.
Covers handling precautions for hydraulic fluid, recommended types, and a detailed system flushing procedure.
Provides instructions for removing and installing the hydraulic pump on 3084RT models, including torque specifications.
Explains the dynamic braking circuit and provides instructions for housing and shaft disassembly/assembly for front wheel motors.
Provides disassembly and assembly instructions for the DT710 rear wheel motors with integral brakes.
Describes the steering system components and operation, including hydraulic cylinders and control valves.
Details the platform leveling system, its hydraulic cylinders, and control by the GP400 processor.
Explains the lift system operation for both 3084RT and 3084ES models, including lowering speed regulation.
Provides safety warnings and procedures for cylinder disassembly, including preparation and cleaning steps.
Describes the electrical control system, including lower and upper controls, and emergency stop functions.
Covers battery warnings, maintenance, and specific battery configurations for 3084RT and 3084ES models.
Provides step-by-step instructions for safely removing and installing batteries, including necessary precautions.
Details the controls and functions available on the upper control station for 3084RT models.
Describes the location of GP400 modules and where to find diagnostic and wiring information.
Details the procedures for GP400 calibration, including sensor calibration and specific model calibrations (ANSI/CE).
Describes the major components of the machine and the steps required to service them.
Covers inspection of tires for faults and warnings regarding the use of approved replacement tires.
Discusses the electronic control system design for low maintenance and troubleshooting protection for modules.
Details procedures for checking and adjusting pressure relief valves on the hydraulic system for 3084RT models.
Covers common issues for 3084ES hydraulic fluid pumps and electrical system malfunctions.
Discusses the electronic control system for 3084ES models, highlighting module protection and high-pressure washing warnings.
Introduces the EZ-Cal scan tool for system information and adjustments, detailing its connection and basic operation.
Lists shutdown HELP messages that prevent specific functions from being used, detailing causes and flash codes.
Provides a guide to diagnose problems by matching symptoms to possible causes and remedies, emphasizing EZ-Cal use.
