Mec Micro 26 - Maintenance; Safety During Maintenance

Page 21 Micro 26 - Service & Parts Manual
April 2019Section 11 - Maintenance
Pre-Start Inspection Checklist
Items on this checklist should be inspected before each work shift. A copy of this checklist is available
in the notes section of this manual. Photocopy the Pre-Start Inspection Checklist to keep record of
this inspection.
30-Day Service
The 30 day maintenance procedure is a one-time procedure to be performed after the first 30 days or
40 hours of usage. These procedures are also performed at later intervals.
Maintaining the tires and wheels in good condition is essential to safe operation and good
performance. Tire and/or wheel failure could result in a machine tip-over. Component damage may
also result if problems are not discovered and repaired quickly.
Check the tire surface and sidewalls for cuts, cracks and unusual wear.
Check each wheel for damage, bends and cracks.
Check each wheel bolt for proper torque (38 ft-lbs/51 Nm dry).
Hydraulic Filter & Breather Cap
ART_5124
Hydraulic
Pump & Motor
Hydraulic
Reservoir
Hydraulic
Filter
Controls
Tray
Breather Cap
Replace the Hydraulic Filter element after the first 30 days of
machine use.
After that, replace the Breather Cap Filter and Hydraulic Filter
every year or 300 hours (whichever comes first).
If the machine is used in very dusty, exceptionally hot or
exceptionally cold conditions, replace the Breather Cap Filter and
Hydraulic Filter every 6 months or 150 hours (whichever comes
first).
Frequent Inspection Checklist
THIS CHECKLIST MUST BE USED AT 3-MONTH INTERVALS OR EVERY
150 HOURS OF MACHINE USE, WHICHEVER OCCURS FIRST. FAILURE
TO DO SO COULD RESULT IN DEATH OR SERIOUS INJURY.
Frequent Maintenance Inspections should be conducted by qualified service technicians only.
Photocopy the Frequent Inspection Checklist page from the Operator’s Manual to keep record of
this inspection. Keep inspections records up to date. Record and report all discrepancies to your
supervisor.
Perform all checks listed on Pre-Start Inspection, then proceed with the following checks.
1.
2.
3.