Mec Micro 26 - Page 29

Page 25 Micro 26 - Service & Parts Manual
April 2019Section 11 - Maintenance
Turn the key switch to ground control and turn the red Emergency Stop button clockwise to the
on position at both the ground and platform controls.
Push in the red Emergency Stop button at the ground controls to the off position.
Result: No machine functions should operate.
Turn the key switch to platform control and turn the red Emergency Stop button clockwise to the
on position at both the ground and platform controls.
Push in the red Emergency Stop button at the platform controls to the off position.
Result: No machine functions should operate.
Note:The red Emergency Stop button at the ground controls will stop all machine operation, even if
the key switch is switched to platform control.
Key Switch
Proper key switch action and response is essential to safe machine operation. The machine can be
operated from the ground or platform controls and the activation of one or the other is accomplished
with the key switch. Failure of the key switch to activate the appropriate control panel could cause a
hazardous operating situation.
Perform this procedure from the ground using the platform controls. Do not stand in the platform.
Turn the red Emergency Stop button clockwise to the on position at both the ground and
platform controls.
Turn the key switch to platform control.
Check the up/down function from the ground controls.
Result: The machine functions should not operate.
Turn the key switch to ground control.
Check the machine functions from the platform controls.
Result: The machine functions should not operate.
Turn the key switch to the off position.
Result: No function should operate from either control station.
Horn
The horn is activated at the platform controls and sounds at the ground as a warning to ground
personnel. An improperly functioning horn will prevent the operator from alerting ground personnel of
hazards or unsafe conditions.
Turn the key switch to platform control and turn the red Emergency Stop button clockwise to the
on position at both the ground and platform controls.
Push down the horn button at the platform controls.
Result: The horn should sound.
Drive Brakes
Proper brake action is essential to safe machine operation. The drive brake function should operate
smoothly, free of hesitation, jerking and unusual noise.
Perform this procedure with the machine on a firm level surface that is free of obstructions, with the
platform extension deck fully retracted and the platform in the stowed position.
1.
2.
•
3.
4.
•
1.
2.
3.
•
4.
5.
•
6.
•
1.
2.
•