Mec Micro 26 - Pre-Start Inspection

Page 26 Micro 26 - Service & Parts Manual
April 2019Section 11 - Maintenance
Mark a test line on the ground for reference.
Turn the key switch to platform control and turn the red Emergency Stop button clockwise to the
on position at both the ground and platform controls.
Press the drive select button.
Choose a point on the machine (i.e., contact patch of a tire) as a visual reference for use when
crossing the test line.
Bring the machine to top drive speed before reaching the test line. Release the function enable
switch or the joystick when your reference point on the machine crosses the test line.
Measure the distance between the test line and your machine reference point.
Result: The machine stops within the specified braking distance. No action required.
Result: The machine does not stop within the specified braking distance.
Note:The brakes must be able to hold the machine on any slope it is able to climb.
Replace the brakes and repeat this procedure beginning with step 1.
Maximum Braking Distance
24 in ± 11.8 in
61 cm ± 30 cm
High Speed on paved surface
Drive Speed - Stowed
Proper drive functions are essential to safe machine operation. The drive function should respond
quickly and smoothly to operator control. Drive performance should also be free of hesitation, jerking
and unusual noise over the entire proportionally controlled speed range.
Perform this procedure with the machine on a firm, level surface that is free of obstructions.
Create start and finish lines by marking two lines on the ground 40 ft /12.2 m apart.
Turn the key switch to platform control and turn the red Emergency Stop button clockwise to the
on position at both the ground and platform controls.
Lower the platform to the stowed position.
Press the drive function select button.
Choose a point on the machine; i.e., contact patch of a tire, as a visual reference for use when
crossing the start and finish lines.
Bring the machine to top drive speed before reaching the start line. Begin timing when your
reference point on the machine crosses the start line.
Continue at full speed and note the time when your reference point on the machine passes over
the finish line. The time should be 10 -14 seconds.
Drive Speed - Raised
Proper drive functions are essential to safe machine operation. The drive function should respond
quickly and smoothly to operator control. Drive performance should also be free of hesitation, jerking
and unusual noise over the entire proportionally controlled speed range.
Perform this procedure with the machine on a firm, level surface that is free of obstructions.
Create start and finish lines by marking two lines on the ground 40 ft /12.2 m apart.
Turn the key switch to platform control and turn the red Emergency Stop button clockwise to the
on position at both the ground and platform controls.
1.
2.
3.
4.
5.
6.
•
•
7.
1.
2.
3.
4.
5.
6.
7.
1.
2.