Page 23 Micro 26 - Operator’s Manual
March 2019Section 8 - Maintenance
To Extend and Retract the Deck Extension
ART_5025
Deck Extension
Release Pedal
Press the platform lock pin foot pedal on the extension deck.
Push the platform extension guardrail to extend the platform to the
desired position.
Do not stand on the platform extension while extending or retracting it.
IF THE ROLL-OUT DECK IS EXTENDED CHECK
FOR CLEARANCE UNDER DECK AREA BEFORE
LOWERING PLATFORM.
1.
2.
Error Indicator Readout
The Error Indicator Readout is located at the Upper Controls station. Consult
the Service & Parts Manual for Alarm Code descriptions. Manuals are available
free online at www.MECawp.com.
If a load in excess of the rated load is detected the lift or lower will be
restricted. The load must be removed before movement can occur.
The platform overload is measured when the machine is stationary and not in
motion.
Shutdown Procedure
When finished with the machine, place the platform in the stowed position.
Park the machine on a level surface.
Turn the Key Switch to the OFF position and remove the key to prevent unauthorized use.
Carefully exit the platform using a constant three (3) point dismount/grip.
Always put the main power switch in OFF position when leaving the machine at the end of the work
day.
Charge the batteries.
To Next Page
Loading...
