Mec Micro 26 - Annual InspectOn Report; Section 9 - Decals

Page 29 Micro 26 - Operator’s Manual
March 2019Section 8 - Maintenance
Annual Inspection Report
1401 S. Madera Avenue, Kerman, CA 93630 USA
1 - 877 - 632 - 5438 1 - 559 - 842 - 1500
Fax: 1 - 559 - 842 - 1520
info@MECawp.com www.MECawp.com
Aerial Platform Sales Corp
Date
Serial Number
Model Number
Date Of Last Inspection
Date Placed In Service
Customer
Street
City/State/Zip
Phone Number
Contact
Dealer
Street
City/State/Zip
Phone Number
Contact
Key:
“Y” Yes / Acceptable
“N” No / Unacceptable
“R” Repaired
“U” Unnecessary / Not Applicable
Check each item listed below.
Use proper Operator’s, Service and Parts manual for specific information and settings.
If an item is found to be “Unacceptable” make the necessary repairs and check the “Repaired” box.
When all items are “Acceptable”, the unit is ready for service.
•
•
•
•
Y N R U Y N R U Y N R U
Decals: Base: Operation:
Proper Placement/Quantity Cover Panels Secure Wires Tight
Legibility Base Fasteners Tight Switches Secure
Correct Capacity Noted Bolts Tight All Functions Operational
Rails: Axle/Wheel Assemblies: Emergency Down:
All Rail Fasteners Secure Wheel Mounting Secure Operational
Entry Gate Closes Properly Steering Cylinder Pins Secure Slow Speed Limit Switch:
Manual/Safety Data In Box Pivot Points Lubed Set Properly
Check/Lube Steering Yokes Pothole Bars:
Extending Platform: Operate Smoothly
Slides Freely Lock In Place
Latches In Stowed Position Limit Switches Adjusted
Latches In Extended Position Component Area: Pressures & Hydraulics:
Cable Secure Valve Manifold(s) Secure Oil Level Correct/Chg
Hoses Tight/No Leaks Steering Pressure Set
Platform: D/C Mtr(s) Secure/Operational Lift Pressure Set
Platform Bolts Tight Contactors Secure Replace Breather Cap
Platform Structure Pump Secure Replace Hydraulic Filter
Batteries: Inspect Hydraulic Oil;
Secure Replace If Needed
Fully Charged
Wire Harnesses: Battery Charger:
Mounted Correctly Secure
Physical Appearance Operational
110/220V Outlet Safe/Working Emergency Stop:
Elevating Assembly: Breaks All Circuits
Beam Structures Maintenance Lock:
Welds Secure
Retaining Rings Operational
Cylinder Pins Secure
Scissor Slide Blocks*
*See Service & Parts Manual for instructions
Signature/Mechanic: Date:
Signature/Owner-User: Date:
P/N 90728 Rev. 3 -- 4555SE
Comments: