Page 10 Mast Series - Operator’s Manual
April 2021Section 4 - Hazards and Safety Rules
Fall Hazard
The guard rail system provides fall protection.
If required by local, state or employer rules, the occupant in the platform must
wear a full body harness with a lanyard attached to an authorized lanyard
anchorage point. Attach only one (1) lanyard per lanyard anchorage point.
Do not sit, stand or climb on the platform guard rails. Maintain a firm footing on
the platform floor at all times.
Do not climb down from the platform when raised.
Keep the platform floor clear of debris. Close the entry gate before operating.
Do not enter or exit the platform unless the machine is in the stowed position.
Collision Hazard
Be aware of limited sight distance and blind spots when driving or operating.
Take extra care when driving with the platform elevated.
Check the work area for overhead obstructions or other possible
hazards. Maintain good observation during operation.
Be aware of crushing hazards when grasping the platform guard rail.
Operators must comply with employer, job site and governmental
rules regarding use of personal protective equipment.
Observe and use color-coded direction arrows on the platform controls and platform decal plate for
drive and steer functions.
Do not operate a machine in the path of any crane or moving overhead machinery unless the controls
of the crane have been locked out and/or precautions have been taken to prevent any potential
collision.
No stunt driving or horseplay while operating a machine.
Do not lower the platform unless the area below is clear of personnel and obstructions.
Limit travel speed according to the condition of the ground surface, congestion, slope, location of
To Next Page
Loading...
