Page 11 Mast Series - Operator’s Manual
April 2021Section 4 - Hazards and Safety Rules
personnel, and any other factors which may cause collision.
Component Damage Hazard
Do not use any battery or charger greater than 24V.
Do not use the machine as a ground for welding.
Explosion and Fire Hazard
Do not operate the machine or charge the battery in hazardous locations or locations where
potentially flammable or explosive gases or particles may be present.
Damaged Machine Hazard
Do not use a damaged or malfunctioning machine.
Conduct a thorough pre-start Inspection of the machine and test all functions before each work shift.
Immediately tag and remove from service a damaged or malfunctioning machine.
Be sure all maintenance has been performed as specified in this manual
Be sure all decals are in place and legible.
Be sure the manuals are complete, legible and in the storage container located in the platform.
Bodily Injury Hazard
Do not operate the machine with a hydraulic oil or air leak. An air leak or hydraulic leak can penetrate
and/or burn skin.
Improper contact with components under any cover will cause serious injury. Only trained
maintenance personnel should access compartments. Access by the operator is only advised
when performing a pre-start Inspection. All compartments must remain closed and secured during
operation.
Battery Safety
Burn Hazard
Batteries contain acid. Always wear protective clothing and eye wear
when working with batteries.
Avoid spilling or contacting battery acid. Neutralize battery acid spills
with baking soda and water.
To Next Page
Loading...
