11 of 64
Telephone: 1300 884 987
Internet: www.medion.com.au
After Sales Support
4. Setting Up of the All-In-One PC
Diagram reference: B
You can freely adjust the monitor up and downwards so you can use it at different
angles.
4.1. Setup Location
• Keep your All-In-One PC and all connected devices away from moisture and
avoid dust, heat and direct sunlight. Non-compliance with these instructions can
lead to faults or damage to the All-In-One PC.
• Do not use the All-In-One PC outdoors because external elements, such as rain,
snow, etc., could damage it.
• Set up and operate all components on a stable, level and vibration-free surface
to prevent the All-In-One PC from falling down.
• Do not operate the All-In-One PC or power adaptor for long periods on your lap
or any other body part as the heat dissipation on the underside can result in
uncomfortable overheating.
4.2. Environmental Requirements
• The All-In-One PC can be operated at an ambient temperature of between
10° and 35°C (+41° and +95°F) and at a relative humidity of between 30% and
80% (without condensation).
• When powered off, the All-In-One PC can be stored at temperatures between
• 0° C and 50° C (+32° F and 122° F).
• Unplug the cable during thunderstorms and especially make sure to remove
the antenna cables, if present. We recommend the use of a surge protector for
additional safety, in order to protect your PC from being damaged by power
peaks or lightning strikes through the power network.
• After transporting the All-In-One PC, wait until the device has reached
room temperature before switching it on. Large changes in temperature or
fluctuations in humidity can cause moisture build up within the All-In-One PC
due to condensation. This can cause an electrical short circuit.
• Keep the original packaging in the event the device needs to be sent in the post.
8806 Aldi AUS RC2 Content.indd 118806 Aldi AUS RC2 Content.indd 11 07.11.2012 12:06:4607.11.2012 12:06:46
To Next Page
Loading...
Need help?
General
