MAC/MTT-OPS-1
26 FEB 2019
SECTION 1
Definitions and Abbreviations
1-4
Rotating Shaft (8)
This safety label is located on the pump.
Do not place your hand or tools within pump bell
while pump is rotating and/or pressure held within
the motor supply hose. Refer to the Operator and
Maintenance Manual for the procedures to operate
and maintain the pump. Failure to follow proper
procedures could result in serious injury.
High Pressure Spray heads (9)
This safety label is located on the spray bar.
Do not operate spray heads until all personnel are
a safe distance away from the vehicle.
High Pressure Water Cannon (10)
This safety label is located on top of the cab control
box.
Do not operate the water cannon until all
personnel are a safe distance away from the
vehicle.
High Pressure Motor (11)
This safety label is located on the hydraulic motor.
Hydraulic motor and supply lines contain oil under
high pressure. Improper removal and repair
procedures could cause severe injury. To remove or
repair, instructions in the Maintenance Manual
must be followed.
To Next Page
Loading...