REPAIR AND WARRANTY
The instrument circuit contains static sensitive devices, and care must be taken in handling the
printed circuit board. If the protection of an instrument has been impaired it should not be used, and
be sent for repair by suitably trained and qualified personnel. The protection is likely to be impaired
if, for example, the instrument shows visible damage, fails to perform the intended measurements,
has been subjected to prolonged storage under unfavourable conditions, or has been exposed to
severe transport stresses.
New Instruments are Guaranteed for 1 Year from the Date of Purchase by the User.
Note
: Any unauthorized prior repair or adjustment will automatically invalidate the Warranty.
Instrument Repair and Spare Parts
For service requirements for Megger Instruments contact
Megger Limited or Megger
Archcliffe Road Valley Forge Corporate Center
Dover 2621 Van Buren Avenue
Kent CT17 9EN Norristown
England PA 19403 U.S.A.
Tel: +44 (0)1304 502243 Tel: +1 (610) 676-8579
Fax: +44 (0)1304 207342 Fax: +1 (610) 676-8625
Returning an Instrument for Repair
If returning an instrument to the manufacturer for repair, it should be sent, freight pre-paid, to the
appropriate address. A copy of the Invoice and of the packing note should be sent simultaneously by
airmail to expedite clearance through Customs. A repair estimate showing freight return and other
charges will be submitted to the sender, if required, before work on the instrument commences.
To Next Page
Loading...
Need help?
General
