The instrument circuit contains static sensitive devices,
and care must be taken in handling the printed circuit
board. If the protection of an instrument has been
impaired it should not be used, and be sent for repair by
suitably trained and qualified personnel. The protection is
likely to be impaired if, for example, the instrument shows
visible damage, fails to perform the intended
measurements, has been subjected to prolonged storage
under unfavourable conditions, or has been exposed to
severe transport stresses.
N ew Instruments are Guaranteed for 1 Year from the
Date of Purchase by the User.
Note: Any unauthorized prior repair or adjustment will
automatically invalidate the Wa r r a n t y.
Instrument Repair and Spare Pa rt s
For service requirements for Megger Instruments contact
M e gger Limited o r M e gge r
A r c h c l i ffe Road Valley Forge Corporate Center
D o v e r 2621 Van Buren Av e n u e
Kent CT17 9EN Norristown
E n g l a n d PA 19403 U.S.A.
Tel: +44 (0)1304 502243 Tel: +1 (610) 676-8579
Fax: +44 (0)1304 207342 Fax: +1 (610) 676-8625
or an approved repair company.
A p p roved Repair Companies
A number of independent instrument repair
companies have been approved for repair work on most
Megger instruments, using genuine Megger spare parts.
Consult the Appointed Distributor/Agent regarding spare
parts, repair facilities and advice on the best course of
action to take.
Returning an Instrument for Repair
If returning an instrument to the manufacturer for repair, it
should be sent, freight pre-paid, to the appropriate
address. A copy of the Invoice and of the packing note
should be sent simultaneously by airmail to expedite
clearance through Customs. A repair estimate showing
freight return and other charges will be submitted to the
s e n d e r, if required, before work on the instrument
c o m m e n c e s .
41
Repair and Warranty
To Next Page
Loading...
