MTO210 Series PowerDB Lite
AVTMTO210 Rev 7 Sept 2013
45
Using PowerDB Lite
1. HOME
1. Select your Instrument MTO210 from the Instrument Setup screen.
a. You can always view the Instrument Setup screen from the Tools
menu or F3.
b. The MTO uses serial communication. Select the appropriate
communication settings on the Serial Device Configuration screen.
c. Use the Refresh button to find any ports that may have not been
connected at the startup of PowerDB Lite. If you are using a USB
serial port and do not know the port assigned to it please perform the
following:
1. Remove the USB serial adapter.
2. Press Refresh.
3. Click on the Port Drop Down and record the options.
4. Plug the adapter back in.
5. Press Refresh.
6. Select the port that was not in the original list.
Verify that the baud rate is set to 9600, Parity is set to none, Byte Size is set to 8,
and Stop Bits is set to 1.
To Next Page
Loading...
