After resetting, the Main Module arrows lights turn off and all modules LED’s will be
SOLID GREEN.
If the reset sequence does not begin, make sure that:
The Power cable and USB cable are correctly connected,
Positioner door, Recognition Sensor door and Spine door are correctly closed
(refer to “PRESENTATION” in the “BNR&BNA6 USER GUIDE” chapter),
Each module is correctly inserted,
Interlock System is correctly locked (refer to “LOCKS AND SECURITY
PRINCIPLE”).
If one or several modules LED’s do not turn to solid green, refer to “BASIC
TROUBLESHOOTING”.
To Next Page
Loading...
