2.6. BNR/BNA6 RESET
The reset sequence of the BNR/BNA6 takes approximately 15 to 25 seconds. It is
dependent on the BNR/BNA6 configuration (number of modules). Reset
automatically tests the BNR/BNA6’s electro-mechanical system for a failure or
banknote in the transport system. If a banknote is found, it will be send the note to
the Cash-Box.
NOTE: The first Reset cycle may take up to 1 minute 30 seconds.
If the Loader Cassette is empty, its LED indicator will blink Red. This will not
affect the BNR readiness to accept cash.
During the reset sequence:
You will hear running of the transport motors, belts and diverters being tested
inside the BNR/BNA6.
You will see module LED’s BLINKING GREEN SLOWLY.
To Next Page
Loading...
