MeiTrack T711L - Setting the Idling Alert - B14; Setting the Harsh Acceleration or Harsh Braking Alert - BBD

MEITRACK T711L GPS Vehicle Tracker User Guide
Copyright © Meitrack Group 2021. All rights reserved. - 13 -
Description:
Connection mode = 0: function disabled.
Connection mode = 1: function enabled. Use the TCP/IP reporting mode.
Connection mode = 2: function enabled. Use the UDP reporting mode.
IP address: IP address or domain name. Contains a maximum of 32 bytes.
Port: contains a maximum of 5 digits.
APN/APN user name/APN password: contains a maximum of 32 bytes respectively. If no user name and password are
required, leave them blank.
Example:
SMS sending: 0000,A21,1,server.meigps.com,8800 ,CMNET,,
SMS reply: 353358017784062,A21,OK
6.5.4 Setting the Idling Alert – B14
SMS sending: 0000,B14,Consecutive time (second),Speed (km/h),Alert Time (second)
SMS reply: IMEI,B14,OK
Description:
This command is used to detect whether an idling alert is generated. The device's input 1 must be connected to ACC
detection. Otherwise, the function is unavailable.
Consecutive time and alert time: indicate the consecutive time for the speed and alert time respectively. The value of
the two parameters ranges from 0 to 60000. Unit: second.
Speed: The parameter value ranges from 0 to 200. Unit: km/h. (Recommended value: 5 km/h)
An idling alert is generated when the following conditions are met simultaneously: the device detects that the ACC is
on, the driving speed is smaller than the preset value, and the consecutive time for the speed is larger than the preset
value.
If you want to read the command settings, send 0000,B14.
Note: The alert activation conditions may be affected due to static drift. Therefore, it is recommended that you should
set the speed to a value between 5 km to 10 km and the consecutive time for the speed to a value that is larger than
60 seconds. The alert time is unavailable temporarily. It is recommended that you should set this parameter to 0.
Example:
SMS sending: 0000,B14,60,5,0
SMS reply: 353358017784062,B14,OK
6.5.5 Setting the Harsh Acceleration or Harsh Braking Alert – BBD
SMS sending: 0000,BBD,X1,Y1,Z1,X2,Y2,Z2
SMS reply: IMEI,BBD,OK/<Error code>
Description:
X1: indicates the initial speed after the vehicle accelerates suddenly. Unit: km/h. The maximum parameter value is 480.
Y1: indicates the increased speed after the vehicle accelerates suddenly. Unit: km/hr/sec. The parameter value ranges
from 0 to 1000.
Z1: indicates the detection time of the harsh acceleration alert. Unit: second. The parameter value ranges from 1 to 255.
X2: indicates the initial speed after the driver brakes sharply. Unit: km/h. The maximum parameter value is 480.
Y2: indicates the increased speed after the driver brakes sharply. Unit: km/hr/sec. The parameter value ranges from -
1000 to 0.