MeiTrack T711L - Starting the Engine by Ibutton; Product Functions and Specifications; Product Functions; Position Tracking

MEITRACK T711L GPS Vehicle Tracker User Guide
Copyright © Meitrack Group 2021. All rights reserved. - 5 -
2.1.4 Starting the Engine by iButton
After swiping the authorized iButton key, the driver must start the engine within one minute. Otherwise, the device's
output 1 is triggered (engine cut-off), and thus the driver cannot start the vehicle. If you want to start the engine, you
must swipe the iButton key again.
Before starting the engine, ensure that:
1. The device's input 1 is connected to the engine detection cable.
2. An iButton key has been authorized.
3. The device's output 1 is connected to the engine control cable through a relay.
4. The RFID ignition function has been enabled by Meitrack Manager or MS03 tracking platform.
5. The RFID event has been enabled on Meitrack Manager. Otherwise, the function is unavailable.
3 Product Functions and Specifications
3.1 Product Functions
3.1.1 Position Tracking
 GPS + LBS positioning
 Real-time location query
 Tracking by time interval
 Tracking by distance
 Tracking by mobile phone
 Speeding alert
 Cornering report
3.1.2 Anti-Theft
 Polygonal geo-fence
 Engine or vehicle door status alert
 Remote vehicle fuel or power cut-off
 GPS blind spot alert
 Towing alert
3.1.3 Other Functions
 SMS or GPRS (TCP or UDP) communication (Meitrack protocol)
 Built-in 8 MB flash for recording driving routes
 IP67 water resistance rating
 Mileage report
 Deep sleep mode
 Built-in 3-axis accelerometer
 GPS data filtering
 Stop Moving and Start Moving alerts
 Vehicle power protection
 Set the output port status based on events