MeiTrack VT300 - GPRS Tracking via Meiligao Protocol; Set Tracker GPRS ID; Configure APN Settings; Set IP and Port for GPRS

- 10 -
7.6 Track by GPRS (Meiligao Protocol) between Server and Tracker
7.6.1 Set Tracker’s GPRS ID
Command: W******,010,ID
Description: Sets a digital GPRS ID for the tracker.
Note:
GPRS ID must not be over 14 digits.
Example:
W000000,010,00001
7.6.2 Set APN
Command: W******,011,APN,Username,Password
Description: Set APN details for the tracker
Note:
1. APN username and password are optional. If no APN username and password are required, just input APN
only;
2. APN defaulted as „CMNET‟;
3. APN + username + password should not over 39 characters.
Example:
W000000,011,CMNET,Meiligao,6688
W000000,011,CMNET
7.6.3 Set IP and Port
Command: W******,012,IP,Port
Description: Set the IP and Port of tracker for GPRS communication.
Note:
1. IP is your server‟s IP or the domain name.
2. Port: [1,65534].
Example:
W000000,012, 220.121.7.89,8500
W000000,012,www.meiligao.net,8500
7.6.4 Set DNS Server IP (optional)
Command: W******,009,DNS Server IP
Description: If the domain name you set by the last command (W******,012,IP, Port) doesn‟t work, your
servers IP is not properly set. You can first use this command to set DNS Server IP (please check with your
DNS server provider for the DNS Server IP) and then redo the command W******,012,IP, Port.
Example: W000000,009,220.23.4.90
7.6.5 Enable GPRS Tracking
Command: W******,013,X
Description: Enable GPRS tracking function.
Note:
X=0, to turn off GPRS tracking (default);