MeiTrack VT300 - Contacts

- 24 -
SIM has PIN code set
Remove PIN code by inserting SIM in you phone and deleting the code
SIM is warped or damaged
Inspect SIM, clean the contacts. If re-inserting does not help try another to
see if it will work
Roaming not enabled
If you are in a different country your SIM account must have roaming
enabled
Error connecting GSM antenna
Make sure the GSM antenna is connected to the GSM interface
Problem: SMS received starts with ‘Last…’
Possible Cause:
Resolution:
Unit does not have clear view of the sky
Move the antenna of the unit to a location where the sky is visible
VT300 is in an inner place
Wait for the target to come out
Battery is low
Recharge the unit and the GPS will start working
Error connecting GPS antenna
Make sure the GPS antenna is connected to the GPS interface
Problem: Unit Fails to Connect to Server via GPRS
Possible Cause:
Resolution:
SIM card in VT300 does not support GPRS
function
Enable SIM card GPRS function
GPRS function of VT300 is turned off
Turn on GPRS function of VT300
Incorrect IP address or PORT
Get the right IP address and PORT and reset to VT300
GSM signal is weak
Move the unit to a location with good GSM reception
Contacts
Please do not hesitate to email us at info@meitrack.com if you have any questions.