MeiTrack VT300 - Speeding Alarm Configuration; Movement and Geo-fence Alerts; Movement Alarm Setup; Geo-fence Alarm Configuration

- 12 -
9. Speeding Alarm
Command: W******,005,XX
Description: Turn on speeding alarm. When the tracker speeds higher than the preset value, it will send an
SMS to the phone number for SOS.
Note: XX is the preset value of speed and in 2 digits.
=00 , to turn off this function;
=[01, 20] (unit: 10Km/h).
Example: W000000,005,08
When the tracker‟s speed is over 80km/h, an SMS alarm will be sent out.
10. Movement/Geo-fence
10.1 Movement Alarm
Command: W******,006,X
Description: When the tracker moves out of a preset circle scope, it will send an SMS alarm to the
authorized phone number for SOS.
Note:
1. X is the preset radii to the tracker‟s original place.
=0, to turn off this function.
=1, 30m
=2, 50m
=3, 100m
=4, 200m
=5, 300m
=6, 500m
=7, 1000m
=8, 2000m
2. Radii: [1, 4294967295] meter(s), suggest to be set above 100 meters.
3. GPRS command is 0x12.
Example: W000000,006,1
When tracker moves out of this circle scope, it will send out an SMS alarm.
10.2 Geo-fence Alarm
Command: W******,302,X
Description: Turns on Geo-fencing alarm. When the tracker moves in/out the preset scope, it will send an
SMS alarm to the authorized phone number for SOS.
1. X is the parameters which includes: latitude, longitude, radii, in, out.
2. Latitude and longitude should be in ASCII format as follows:
Latitude is ddd.dddddd, „0‟ is needed to be stuffed if no value available. „-‟ should be added for south.