MeiTrack VT300 - Page 19

- 19 -
Presetting by SMS for GPRS tracking (Ensure that your SIM card supports GPRS connection prior to setting)
Set Tracker’s GPRS ID
W******,010,ID
W000000,010,00001
Remarks: to set a digital GPRS ID for the tracker.
GPRS ID must not over 14 digits.
Set APN
W******,011,APN,Username,
Password
W000000,011,CMNET,Meiligao,6688
W000000,011,CMNET
Remarks: If no APN username and password are required, just input APN only.
APN defaulted as „CMNET‟.
APN + username + password should not over 39 characters.
Set IP and Port
W******,012,IP,Port
W000000,012, 220.121.7.89,8500
W000000,012,www.meiligao.net,8500
Remarks: IP is your server‟s IP or the domain name. Port: [1,65534].
Set DNS Server IP
W******,009,DNS Server IP
W000000,009,220.23.4.90
Remarks: If the domain name you set by the last command (W******,012,IP, Port) doesn‟t work, your server IP is not properly
set. You can first use this command to set DNS Server IP (please check with your DNS server provider for the DNS Server IP)
and then redo the command W******,012,IP,Port.
Enable GPRS Tracking
W******,013,X
W000000,013,1
Remarks:
X=0, to turn off GPRS tracking (default);
X=1, to enable GPRS tracking via TCP;
X=2, to enable GPRS tracking via UDP.
Set GPRS Interval
W******,014,XXXXX
W000000,014,00060
Remarks: to set time interval for sending GPRS packets.
XXXXX should be in five digits and in unit of 10 seconds.
XXXXX=00000, to turn off this function;
XXXXX=00001~65535, time interval for sending GPRS packet and in unit of 10 seconds.
In this example, the tracker will send every 600 seconds (10 minutes).
Set Heartbeat Interval
W******,015,data
W000000,015,10
Remarks: to set interval for heartbeat.
Data: in unit of minutes
data=0, to turn off this function;
data=1~65535, set interval for heartbeat.
In this example, the tracker will send heartbeat every 10 minutes.
Set Sensitivity of Tremble
Sensor
W******,035,XX
W000000,035,30