Melco N1A EX - Dismount USB Drive; System Update; Language

75
Chapter 4 Appendix
Network
LAN Port
Configures whether to automatically acquire the IP address from a DHCP
server or enter it manually. If “Fixed IP” is selected, enter the IP address,
subnet mask, default gateway, and DNS server.
Player Port
Selects “Bridged Mode” if the Digital Music Library’s LAN port is connected to
the router.
If connecting the Network Audio Player to the Digital Music Library without
connecting it to the Internet,, select “Isolated Mode”. If you select “Off”, the
Player port will be disabled.
Rear Side LED
*
Configure whether to turn off the rear LAN and Player port LEDs.
Friendly Name Changes the friendly name (hostname) of the Digital Music Library.
*This setting is only available on the N1 EX.
Drive
Format Internal Drive
Formats the internal drives of the Digital Music Library. When formatting on
the N1 EX, you can change the current RAID mode to a spanned, RAID 0, or
RAID 1 array.
If you select “Erase All Data”, all data on the drives will be completely erased.
Data removed this way will be nearly impossible to recover with the current
tools.
Format USB Drive
Formats the USB drive.
If you select “Erase All Data”, all data on the drives will be completely erased.
Data removed this way will be nearly impossible to recover with the current
tools.
Initialize Settings
Restores the Digital Music Library settings to the factory default.
Dismount USB Drive
Dismounts a USB drive connected to the front USB 3.0 port on the N1 EX, or a USB drive connected to the USB 2.0
port on the N10/N100 and for which “Mount and Scan” had been selected as an action. This menu will show which
USB port a USB drive is connected to (either front or rear), and allows you to disconnect a USB drive while the Digital
Music Library is on.
System Update
Internet
Updates the Digital Music Library’s firmware to the latest version via the
Internet. Refer to the “Updating via the Network” section in chapter 3 for the
procedure to update the firmware.
USB
Updates the Digital Music Library’s firmware to the latest version using a USB
device that contains the firmware file. Refer to the “Updating from the USB
Device” section in chapter 3 for the procedure to update the firmware.
Check for Updates at Start-Up
Enables or disables checking for a new firmware release when turning on the
Digital Music Library.
Language
English Changes the display language to English.