First steps
56
GB
3.3 Installing the appliance
Observe the following instructions:
Do not install the appliance in damp rooms.
Install the appliance on a stable, at and dry surface.
Do not install the appliance in the vicinity of sinks or the like.
Do not install the appliance on hot surfaces.
Install the appliance at a sucient distance (approx. 10cm) from the
wall and other objects. The space above the appliance should be at least
20cm.
Route the power cable so it cannot be damaged by edges or hot sur-
faces.
3.4 Connecting the appliance
Observe the following instructions:
Make sure that the supply voltage matches the operating voltage speci-
ed in the technical data (see the Technical data on page89 table).
Only connect the appliance to a properly installed earthing contact
socket. If in doubt, consult a specialist electrician.
The earthing contact socket must have a fuse of at least 10 A.
3.5 Switching on the appliance for the rst time
During initial start-up, the language, the time and the water hardness can
be set. The settings can be changed at a later point in time (see chapter7
Changing basic settings on page74 and section8.8 Setting the water
hardness on page84).
Use the enclosed test strips to determine the water hardness. Observe the
instructions on the test strip packaging and in the table Water hardness
range on page89.
Information
We recommend pouring away the rst two cups of coee after initial
start-up.
If you want to use a water lter, only insert this after starting up for the
rst time.
To Next Page
Loading...
Need help?
General
