Melitta PASSIONE - 6 Changing Basic Settings; Calling up Service Mode; Setting the Energy Save Programme

Changing basic settings
76
GB
4. Turn the rotary regulator anti-clockwise up to the stop.
» Beverage dispensing stops.
5. Remove the vessel.
6 Changing basic settings
The following chapter describes how to change the appliance's basic
settings.
6.1 Calling up service mode
Some of the basic settings can only be changed in the service mode of the
appliance.
Requirement:
The appliance is ready for operation.
1. Press the "Service" button for longer than 2 seconds to call up the
service mode.
» The appliance indicates that it is in one of the service modes described
below.
Each service mode is assigned a display.
Display Meaning in service mode
Energy save programme
Auto OFF
Water hardness
Brewing temperature
Information
All four basic settings can be reset in service mode to the factory settings
(see section6.6 Resetting the appliance to the factory settings on page80).
6.2 Setting the energy save programme
If the adjacent display lights up in service mode, the energy save pro-
gramme can be set.
The energy save programme causes lowering of the heating temperature.
The display on the control panel also becomes dimmer.
If the appliance is not operated for a long time, it automatically switches to
the energy save programme after a specied time.