Basic operation
64
GB
4 Basic operation
This chapter describes basic operating steps for using the appliance on a
daily basis.
4.1 Switching the appliance on and o
Before switching on after starting up the appliance for the rst time, read
section3.5 Switching on and venting the appliance for the rst time on
page62.
Information
– When switched on and o, the appliance performs automatic rinsing.
– During rinsing, rinsing water is also conducted into the drip tray.
Switching on the appliance
1. Place a vessel beneath the outlet.
2. Press the ON/OFF button (7).
3. The appliance heats up and performs automatic rinsing.
» The appliance indicates the last set coee strength.
Information
If the appliance was only switched o briey, there is no automatic rinsing
after switching on.
Switching o the appliance
1. Place a vessel beneath the outlet.
2. Press the ON/OFF button (7).
» The appliance performs automatic rinsing.
» The appliance switches o.
Information
– The appliance switches o automatically when it is not operated for a
long time. Automatic rinsing is also carried out in this case.
– The o time can be set in the service mode (see section6.3 Setting Auto
OFF on page77).
– If no beverage has been prepared since switching on or if the water
tank is empty, no rinsing takes place.