Melitta PASSIONE - Installing the Appliance; Connecting the Appliance; Switching on and Venting the Appliance for the Rst Time

First steps
62
GB
3.3 Installing the appliance
Observe the following instructions:
– Do not install the appliance in damp rooms.
– Install the appliance on a stable, at and dry surface.
– Do not install the appliance in the vicinity of sinks or the like.
– Do not install the appliance on hot surfaces.
– Install the appliance at a sucient distance (approx. 10cm) from the
wall and other objects. The space above the appliance should be at least
20cm.
– Route the power cable so it cannot be damaged by edges or hot sur-
faces.
3.4 Connecting the appliance
Observe the following instructions:
– Make sure that the supply voltage matches the operating voltage speci-
ed in the technical data (see the Technical data on page97 table).
– Only connect the appliance to a properly installed earthing contact
socket. If in doubt, consult a specialist electrician.
– The earthing contact socket must have a fuse of at least 10 A.
3.5 Switching on and venting the appliance for the rst time
Once you switch on the appliance for the rst time, the appliance performs
automatic rinsing. Hot water rst ows out of the Cappuccinatore, then out
of the outlet. The appliance is vented.
CAUTION
Hot water and hot steam owing out of the pipe
 Do not touch the steam pipe during and immediately after use.
 Wait until the steam pipe has cooled down.
Information
– We recommend pouring away the rst two cups of coee after initial
start-up.
– If you want to use a water lter, only insert this after starting up for the
rst time.