Installation
Rev 1.2
Mellanox Technologies
22
5.2 Installing the Switch in the Rack
Tools and Parts
Tools required and customer supplied parts
5.2.1 Table Top Installation
1. Peel and stick the four rubber bumpers into the bottom of the switch. Place them in the round
circles.
Figure 7: Placing the Bumpers
2. Place on a flat surface. Make sure the switch is sits solid on the surface.
3. Connect the power cord.
This installation kit can only be used to install this switch.
• Phillips Screwdrivers #1 and #2 • Grounding screw
• ESD Strap • Grounding wire sufficient to reach a valid ground
•ESD mat
The following procedure can be done by one person.
To Next Page
Loading...
