4
Service IPP 200-500/HPP 108 | 10/2008
About this guide1.
Purpose and target group1.1
This guide describes the service and repair work available for
cooling incubators of types IPP 200–500 and constant climate
chambers of type HPP 108. It is intended exclusively for use by
electrical technicians who are familiar with safety regulations for
electrical engineering.
Related documents1.2
Apart from this service guide, the information and regulations in
the user manual for the respective appliance must also be ob-
served for all service and repair work.
Please refer to the circuit diagrams at the end of this guide for all
work on the electrical system.
Tools needed1.3
The following tools and equipment are required to perform the
work described in this guide:
Torx screwdriver sizes 8 and 10 ►
Phillips screwdriver size 1 ►
Wire-cutting pliers ►
Flat pliers to remove the connection cable ►
Allen key 2 mm for door hinge, ►
1.5 mm for humidity sensor (for HPP 108)
Multimeter with voltage and resistance measuring range ►
Cable ties ►
Adhesive tape to label cables and components ►
Manufacturer address and customer service 1.4
MEMMERT GmbH + Co. KG
Postfach 17 20
91107 Schwabach, Germany
Äußere Rittersbacherstr. 38
91126 Schwabach
Germany
Phone: +49 (0) 09122 / 925-0
Fax: +49 (0) 09122 / 14585
E-mail: sales@memmert.com
Internet: www.memmert.com
Customer Service:
Phone: +49 (0) 09122/925-128
and: +49 (0) 09122/925-126
E-mail: service@memmert.com
For service enquiries, please always specify the appliance number
on the nameplate.
© 2008 Memmert GmbH + Co. KG
Date 10/2008
We reserve the right to make changes
To Next Page
Loading...
