Memmert ULE 800 - General Safety Instructions; Explanation of Symbols; Safe Transport Guidelines

set
°
Ctemp
hdelay
h hold
0I
p
ower heat
fresh air
0
1
2
3
4
5
6
alarm set
UE/BE 200-800, SE 200-400, ULE/SLE 400-800
2
The text of these Operating Instructions has been translated from the German. If
any part of the text is doubtful or the interpretation is unclear, and also in case of
errors, the German original is to be considered as valid.
1 Congratulations on your choice of a MEMMERT Oven!
Manufactured in Germany using the latest production techniques and finest materials
available, you now possess a technically superior and fully developed product. Your oven
has already been under extensive testing in our factory.
For correct operation of the equipment it is essential to observe the operating and
maintenance instructions below. This will ensure that your equipment will give many
years´ satisfactory service.
Explanation of symbols:
These symbols mark important indications in the operating instructions
The corresponding markings on the unit mean:
Note the Operating Instructions!
Attention, outside case temperature may be hot!
General safety instructions:
The physical and chemical properties of your load
(e.g. inflammation temp. etc.) have strictly to be observed, as
otherwise considerable damages (load, oven, surroundings of
apparatus) can appear.
Please note that the Memmert ovens described here are not
explosion-proof (they do not conform to Occupational Association
Regulation VBG 24). They are therefore unsuitable for drying,
evaporating or burning-in of enamels or similar substances whose
solvent may form an inflammable mixture together with air. There
must be no possibility for inflammable or explosive gas/air
mixtures to form either inside the cabinet or in the immediate
neighbourhood of the equipment.
Excessive dust or aggressive vapours in the interior and/or around
the oven may result in sediments within the oven and cause short
circuits or damage to the electronic parts. Therefore dust and
aggressive vapours should be kept from the unit.
Transport:
Always use gloves !
If the ovens have to be carried, at least 2 persons are required for this
mode of transportation depending on size for Models 200 to 500. At
least 4 persons are required for Models 600 and 700.
ATTENTION !
Take special care when oven is working at high temperature!
Outside case temperature may be hot!