Memmert ULE 800 - Working Controller Module Operation; Controller Interface and Basic Operation; Controller Operation Notes

set
°
Ctemp
hdelay
h hold
0I
p
ower heat
fresh air
0
1
2
3
4
5
6
alarm set
UE/BE 200-800, SE 200-400, ULE/SLE 400-800
8
5 Working controller module
set
°
C temp
hdelay
h hold
The controller is operated with the aid of the digital rotary
knob in conjunction with the set-button, as described in
the subsequent chapters.
The multifunction display provides information on
temperature and programme settings.
The functions for different settings of the main switch are
described below.
NOTES :
 If the set-button is not operated, the controller display shows the actual temperature.
 Changing the displayed setpoint is only possible, if the set-button is held down at the
same time. This helps to avoid unintentional changes.
 Turning the rotary knob rapidly changes the setpoint in large steps; turning it slowly
changes the setpoint in single digits.
 When the programming is finished the set values are stored, stay in the memory and
remain stored even if the cabinet is switched off.