Memmert ULE 800 - Glossary of Terms; Key Term Definitions

UE/BE 200-800, SE 200-400, ULE/SLE 400-800
33
.............................................................. page
S
safety device ............................................ 19
safety instructions ....................................... 2
schocks during transport............................. 6
serial communication interface ................. 10
set ............................................ 8, 9, 11, 18
set-button .............................. 8, 9, 11, 18, 25
setting of continuous operation and
programmes.......................................... 13
SP ....................................................... 11, 12
stacking device .......................................... 5
sterilisation .......................................... 22, 24
sterilising cassettes................................... 23
supervision of the programm flow ............. 17
switch-on delay and hold time dependent on
set temperature.................................... 15
..............................................................page
T
technical data summary ..............................3
temp ......................................................... 12
temperature controller .................................8
temperature range.......................................3
temperature setting ...............................9, 11
timer setting.........................................11, 12
transport ......................................................2
W
wall mounting ............................................. 5
working controller module ...................... 8, 9
working temperature range ........................3
21 Glossar:
 nominal temperature = the maximum adjustable set-temperature of the oven.
 ambient temperature = the continuous temperature of the room in which the oven is
set up
 set temperature dependent on operation = the integrated digital timer for the hold
time starts not earlier than the temperature in the chamber has reached the setpoint to
at least 0.5ºC at 70ºC nominal temperature resp. 2ºC at 220/300ºC nominal
temperature.
 steady-state condition = the selected set temperature was reached and is stabilized,
i.e. the setpoint is unvaried at least for 5 minutes.