43
You must remove the left side Valve Access Panel to replace the pressure regulator.
11. Remove the left-side access panel mounted to the left outer skin and lay down gently without disconnecting any
wires of internal components. WARNING: DO NOT FORCE. EXCESSIVE FORCE MAY DAMAGE INTERNAL
WIRING COMPONENTS!
12. See diagrams on this page and identify the Pressure Regula-
tor on the Valve Body.
13. Using a Torx T20 (supplied) or a slotted screwdriver, remove 2
screws that secure the NG Pressure Regulator to the gas
valve body and remove NG Pressure Regulator, see following
page for detailed instructions. Note: Be careful when remov-
ing or tightening the screw on the back-side of the pressure
regulator. The screw location is difficult to access and care
must be taken to ensure a proper seal when tightened.
14. Install the new LP Pressure Regular onto the gas valve body
in the same position and orientation as the NG Pressure
Regulator you removed in Step 2, above. The LP Pressure
Regulator can only be mounted in one position. Secure the LP
Pressure Regulator in place. Tighten down.
REMOVE (4) SCREWS "ONLY"
THAT HOLD LEFT SIDE COVER.
PRESSURE
REGULATOR
PRESSURE
REGULATOR
SCREWS
To Next Page