ENGLISH
132
Replace presser foot
Remove
Turn the handwheel towards you until the needle is in the highest position. Lift the presser foot with the
presser foot lever (1). Pull the small lever (2) on the rear of the presser foot holder towards you to undo
the presser foot.
Replace
Position the presser foot on the stitch plate so that the pin (3) is directly below the presser foot holder’s
cut-out (4). Lower the presser foot lever again and check that the pin is located in the cut-out. Move the
small lever on the rear of the presser foot towards you again. The presser foot now snaps automatically
into place.
To Next Page
Loading...