X
Disconnect cable connector ;.
X
Unclip the retaining spring.
X
Remove bulb =.
X
Insert the new bulb in such a way that its base
fits into the recess of the bulb holder.
Partially masking headlamps – driving
on the left/right
!
Do not use a sharp object to remove the
sticker. Otherwise, you could damage the
headlamp lens.
Mask the headlamps when driving in countries
where vehicles drive on the opposite side of the
road to the country where the vehicle is regis-
tered. This prevents oncoming traffic from being
dazzled. Masked headlamps do not illuminate as
large an area of the edge of the carriageway.
When using the vehicle in other countries
observe the legal requirements for the country
you are currently in.
The driver is responsible for the vehicle lighting
at all times.
Have xenon headlamps switched over at a quali-
fied specialist workshop as close to the border
as possible before crossing into one of these
countries. On your return journey, have the
xenon headlamps switched back to asymmetri-
cal dipped beam as close to the border as pos-
sible.
Halogen headlamps must be masked in accord-
ance with the following Mercedes-Benz specifi-
cations as close to the border as possible before
crossing into one of these countries. Use a com-
mercially available opaque adhesive tape. On
your return journey, remove the adhesive tape
as close to the border as possible.
Headlamp masking surface for right-hand-drive
vehicles for use in countries where vehicles drive
on the left (example: halogen headlamp, version 1)
Headlamp masking surface for right-hand-drive
vehicles for use in countries where vehicles drive
on the left (example: halogen headlamp, version 2)
:
Right headlamp
;
Left headlamp
100
Lighting system
Driver's workstation
To Next Page
Loading...
Need help?
General
