R
Rear axle
R
Transmission
R
Brakes, axle 1/2/3/4/5
R
Air filter
X
To reset the maintenance due date: press
the r or s button to display the
desired maintenance point.
If a reset is possible, the input window shows
Reset?.
X
Press the u button.
The input window shows No/Yes.
X
Use the r button to select the Yes menu
bar and press the u or 9 button to con-
firm.
Monitoring info menu
Reservoir pressure menu window
X
To display the reservoir pressure: use the
u or t button to scroll to ã monitor-
ing info.
The menu window shows the reservoir pres-
sure of brake circuits \ and ^ as a bar
display.
Coolant menu window
X
Use the u or t button to scroll to ã
monitoring info.
X
To display the coolant temperature: use
the r or s button to scroll to the
Coolant menu window.
If the coolant level is too low, the coolant tem-
perature cannot be displayed.
Engine menu window
In the Engine menu window, you can check the
engine oil level and display the engine's operat-
ing hours. Check the engine oil level before the
start of every journey. The engine oil level is not
displayed while driving.
X
Park the vehicle on a level surface.
X
Apply the parking brake.
X
Switch off the engine.
X
Switch the ignition lock to the drive position.
X
Wait at least 5 minutes after switching off the
engine.
i
If you call up the oil level too early or while
the engine is running, Not available
appears in the menu window.
X
Use the u or t button to scroll to ã
monitoring info.
X
To display the engine oil level and operat-
ing hours: use the r or s button to
scroll to the Engine menu window.
The menu window shows:
R
the engine oil level 4, e.g. Oil level
ok or Oil level low and/or Top up
oil: 4 l
R
the ý operating hours of the engine,
e.g. 10000 h 27 min
The service counter is not suitable for
measuring the driving hours of the driver.
Use equipment which is suitable for this
purpose.
X
When the menu window displays Oil level
low or Oil level too low, do not start the
engine. Immediately top up the amount of oil
shown (Y page 360) and check the oil level
again.
If the menu window shows Oil level ok and
Top up oil: 3 l, the engine oil level is suf-
ficient. The amount of oil to top up to reach
the maximum fill level is purely for your infor-
mation. At the moment, you do not need to
top up the oil.
X
If the oil level display is not available, repeat
the oil level check.
X
If it is not possible to display the oil level after
repeated attempts, have the oil level display
checked at a qualified specialist workshop.
Events menu window
You can display stored malfunctions and mes-
sages in the Events menu. If you have rectified
the cause of the malfunction/message, the on-
board computer no longer displays the event.
X
Use the u or t button to scroll to ã
monitoring info.
X
Use the r or s button to scroll to the
Events menu window.
The menu window shows, for example, the
number of events.
X
To display an event: press 9.
X
To show further events: press the r or
s button.
148
On-board computer
On-board computer and displays
To Next Page
Loading...
Need help?
General
