1. Open the fuel tank vent screw on the manual venting type tanks.
a - Fuel cap
b - Manual vent screw
c - Tab lock
2. Position the fuel line primer bulb so the arrow on the side of the bulb is
pointing up. Squeeze the fuel line primer bulb several times until it feels
firm.
IMPORTANT: To prevent engine flooding, do not squeeze the primer bulb
after the engine has warmed up.
3. Insert the lanyard clip into the stop switch. This is the RUN position.
a - Lanyard stop switch
b - Spare lanyard stop switch clip
c - Lanyard
To Next Page
Loading...
