1. With the outboard still in the water, disconnect the remote fuel line and
run engine until it stops. This will drain fuel from the carburetor. Install the
protector cap over the fuel connector.
a - Protector cap
2. Remove outboard and hold it upright until the water is drained out. Keep
the outboard in an upright position when carrying.
3. Carry, transport, or store the outboard in any of the three positions shown.
These positions will prevent oil from draining out of the crankcase.
a - Upright position
b - Tiller handle down
c - Front side down
39056
37-892904-010
THIS SIDE UP
NOTICE
TRANSPORTING
38 eng
To Next Page
Loading...
