IMPORTANT: If no water is coming out of the water pump indicator hole, stop
the engine and check the cooling water intake for obstruction. No obstruction
may indicate a water pump failure or blockage in the cooling system. These
conditions will cause the engine to overheat. Have the outboard checked by
your dealer. Operating the engine while overheated will cause serious engine
damage.
WARMING UP ENGINE
Before beginning operation, allow the engine to warm up at idling speed for
three minutes.
Starting the Engine ‑ Remote Control Models
Before starting, read the Prestarting Check List, special operating
instructions, and Engine Break‑in Procedure.
1. Open the fuel tank vent on the manual venting type tanks.
a - Fuel cap
b - Manual vent screw
c - Tab lock
2. Position the fuel line primer bulb so the arrow on the side of the bulb is
pointing up. Squeeze the fuel line primer bulb several times until it feels
firm.
IMPORTANT: To prevent engine flooding, do not squeeze the primer bulb
after the engine has warmed up.
OPERATION
66 eng
To Next Page
Loading...
Need help?
General
