4. Adjust the water flow (if necessary) so excess water continues leaking out
from around the rubber cups to ensure the engine is receiving an
adequate supply of cooling water.
5. Check for a steady stream of water flowing out of the water pump
indicator hole. Continue flushing the outboard for 3 to 5 minutes, carefully
monitoring water supply at all times.
6. Stop the engine, turn off the water, and remove the flushing attachment.
Install the propeller.
Top Cowl Removal and Installation
REMOVAL
1. Pull out the front cowl latch.
2. Lift front of cowl to clear front latch and push toward the rear to clear rear
hook.
3. Lift top cowl to remove.
INSTALLATION
1. Lower the top cowl into position over the engine.
2. Move the cowl toward the rear to align rear hook. After rear hook has
engaged, move cowl toward front and push down front of cowl.
3. Push in the latch to secure the top cowl.
MAINTENANCE
80 eng
To Next Page
Loading...
Need help?
General
