Mercury 1F10201BK - Outboard Installation Procedures

Installing Outboard
!
WARNING
Failure to correctly fasten the outboard could result in the outboard propelling
off the boat transom resulting in property damage, serious injury, or death.
Before operation, the outboard must be correctly installed with the required
mounting hardware.
BOAT TRANSOM HEIGHT REQUIREMENT
Measure the transom height of your boat. The boat bottom should be aligned or
be within 25 mm (1 in.) above the anti‑ventilation plate of the outboard.
a - Anti‑ventilation plate
INSTALLING OUTBOARD ON TRANSOM
!
WARNING
Failure to correctly fasten the outboard could result in the outboard propelling
off the boat transom resulting in property damage, serious injury, or death.
Before operation, the outboard must be correctly installed with the required
mounting hardware.
This product must be secured to the transom with the required mounting
hardware. If the outboard strikes an underwater object, the required mounting
hardware prevents the outboard from propelling off the transom. A decal on the
swivel bracket reminds the installer of the potential hazard.
Avoid serious injury
or death. Secure
engine to transom
with bolts.
WARNING
37-896853-007
52375
a
27151
INSTALLATION
eng 23