IMPORTANT: Nondetergent oils, multiviscosity oils (other than Mercury or
Quicksilver NMMA FC‑W certified oil or a major brand NMMA FC‑W certified
oil), full synthetic oils, low quality oils, and oils that contain solid additives are
not recommended.
C
+100
+80
+60
+40
+20
0
+38
+27
+16
+4
-7
-18
F
+120
+49
10W-30
25W-40
Engine Oil
70095
Checking Engine Oil
IMPORTANT: Do not overfill. Be sure that the outboard is upright (not tilted)
when checking oil.
1. Turn the engine off. Have the outboard in a level operating position.
Remove the top cowl.
2. Remove the dipstick. Wipe the dipstick with a clean rag or towel and push
it back in all the way.
3. Pull the dipstick out again and observe the oil level. If oil level is low,
remove the oil filler cap and fill to (but not over) the full mark with the
recommended oil.
IMPORTANT: Inspect oil for signs of contamination. Oil contaminated with
water will have a milky color to it; oil contaminated with fuel will have a strong
fuel smell. If contaminated oil is noticed, have the engine checked by your
dealer.
4. Install the oil filler cap and tighten securely.
a - Dipstick
b - Oil filler cap
4914
a
b
FUEL AND OIL
eng 45
To Next Page
Loading...
Need help?
General
