Routine cleaning of the remote control external surfaces is recommended to
prevent a buildup of salt and other environmental debris. Use a cloth towel
which has a sufficient amount of fresh water to dissolve and remove salt or
mineral deposits.
When water marks cannot be removed with a damp cloth, mix a 50/50 solution
of warm water and isopropyl alcohol to clean the remote control. Do not use
acetone, mineral spirits, turpentine type solvents, or ammonia based cleaning
products. The use of strong solvents or detergents may damage the coating,
the plastics, or the rubber components on the remote control.
CLEANING CARE FOR TOP AND BOTTOM COWLS
IMPORTANT: Dry wiping (wiping the plastic surface when it is dry) will result in
minor surface scratches. Always wet the surface before cleaning. Do not use
detergents containing hydrochloric acid. Follow the cleaning and waxing
procedure.
Cleaning and Waxing Procedure
1. Before washing, rinse the cowls with clean water to remove dirt and dust
that may scratch the surface.
2. Wash the cowls with clean water and a mild nonabrasive soap. Use a soft
clean cloth when washing.
3. Dry thoroughly with a soft clean cloth.
4. Wax the surface using a nonabrasive automotive polish (polish designed
for clear coat finishes). Remove the applied wax by hand using a clean
soft cloth.
5. To remove minor scratches, use Mercury Marine Cowl Finishing
Compound (92‑859026K 1).
CLEANING CARE FOR THE POWERHEAD (SALTWATER USE)
If the outboard is operated in saltwater, remove the top cowl and flywheel
cover. Inspect the powerhead and powerhead components for salt buildup.
Wash off any salt buildup from the powerhead and powerhead components
with fresh water. Keep water spray out of the air filter/intake and alternator.
After washing, allow the powerhead and components to dry. Apply Quicksilver
or Mercury Precision Lubricants Corrosion Guard spray on the external metal
surfaces of the powerhead and powerhead components. Do not allow the
Corrosion Guard spray to come in contact with the alternator drive belt or belt
pulleys.
IMPORTANT: Do not allow lubricant or Corrosion Guard spray to come in
contact with the alternator drive belt or the belt pulleys. The alternator drive belt
could slip and be damaged if it becomes coated with any lubricant or Corrosion
Guard spray.
MAINTENANCE
74 eng
To Next Page
Loading...
Need help?
General
