FEATURES AND CONTROLS
30
4. Detent tension adjustment screw - This screw can be adjusted to increase or decrease the effort
to move control handle out of detent positions (cover must be removed). Turning the screw
clockwise will increase tension. Adjust to the desired tension.
a - Detent tension adjustment screw b - Control handle tension adjustment
screw
5. Start/stop button - Allows the boat operator to start or stop the engine without using the ignition
key.
6. Neutral LED - The neutral LED illuminates when engine is in neutral gear position. It also flashes
when throttle only is activated.
NOTE: Gear position is determined by sensing the position of the shift actuator on the engine, not the
position of the control handle.
7. Active LED - The active LED illuminates to show the remote control is active and ready for use.
8. Throttle only/station select button - Allows the boat operator to increase engine RPM for warm-
up, without shifting the engine into gear. To engage throttle only, move the control handle into the
neutral position. Press the throttle only button while moving the control handle ahead to the
forward detent. The horn will sound once and the neutral light will start flashing. The horn will
sound twice when throttle only is engaged. Advance throttle to increase engine RPM. To
disengage, return control handle to neutral position and press the throttle only button. Engine
RPM is limited to prevent engine damage. Pressing the station select button at an inactive helm
initiates a helm transfer. Refer to Helm Transfer.
To Next Page
Loading...
